100% Reliable Microsoft 350-501 Exam Dumps Test Pdf Exam Material
Based on Official Syllabus Topics of Actual Cisco 350-501 Exam
The Cisco 350-501 exam is a certification exam that focuses on implementing and operating service provider network core technologies. This exam validates the skills and knowledge of IT professionals working with service provider network technologies. The exam covers a range of topics such as network architecture, automation, routing protocols, virtualization, and security. Passing this exam enables professionals to demonstrate their expertise in implementing and operating service provider network core technologies, which can open up new career opportunities in the rapidly growing field of service provider networking.
NEW QUESTION # 183
Drag and drop the descriptions from the left onto the corresponding OS types on the right.
Answer:
Explanation:
NEW QUESTION # 184 
Refer to the exhibit. A network engineer is implementing an OSPF configuration. Based on the output, which statement is true?
- A. "IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway.
- B. In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.
- C. OSPFv3 does not run for IPv4 on FastEthernet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface FastEthernet0/0.
- D. OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.
Answer: D
Explanation:
Section: Networking
NEW QUESTION # 185
Drag and drop the LDP features from the left onto the correct usages on the right.
Answer:
Explanation:
NEW QUESTION # 186
Refer to the exhibit:
A network operator working for service provider with an employee id 3715 15:021 applied this configuration to a router.
Which additional step should the engineer use to enable LDP?
- A. Delete the static router ID
- B. Configure the both keyword to enable LDP globally
- C. Enable MPLS LDP on the interface
- D. Disable Cisco Express Forwarding globally
Answer: C
NEW QUESTION # 187 
Refer to the exhibit. Which effect of this configuration is true?
- A. It enables AToM on interface gigabitethernet1/0.
- B. It enables tagging for VLAN 12 on the interface.
- C. It enables MPLS on the interface.
- D. It creates a pseudowire class named cisco.
Answer: A
Explanation:
Section: Architecture
Explanation/Reference: https://community.cisco.com/t5/service-providers-documents/configuration-example-atom-any- transport-over-mpls-for-like-to/ta-p/3144810
NEW QUESTION # 188
Refer to the exhibit.
Refer to the exhibit an engineer working for a private telecommunication company with an employee Id: 4065:96:080 upgrades the WAN link between routers ASBR-101 and ASBR-201 to 1Gb by Installing a new physical connection between the Gi3 Interfaces. Which BGP attribute must the engineer configure on ASBR-201 so that the existing WAN link on Gi2 Is maintained as a backup?
- A. Option C
- B. Option A
- C. Option D
- D. Option B
Answer: A
NEW QUESTION # 189
Which two uses of the YANG data modeling language are true? (Choose two.)
- A. It can be used to access a device by HTTP.
- B. It can be used to replace the OSI model for troubleshooting.
- C. It can be used to model the configuration used by NETCONF operations.
- D. It can be used to replace RESTCONF as a mechanism to install and manipulate configuration.
- E. It can be used to shape state data of network elements.
Answer: B,C
Explanation:
Section: Automation and Assurance
Explanation
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/1611/ b_1611_programmability_cg/configuring_yang_datamodel.pdf
NEW QUESTION # 190
ASN 65001 is peering with ASN 65002 to exchange IPv6 BGP routes. All routes that originate in ASN 65001 have a standard community value of 65001:100, and ASN 65002 is allowed to advertise only
2001:db8:aaaa::/48. An engineer needs to update the ASN 65001 route-filtering configuration to meet these conditions:
* Looped routes into ASN 65001 and routes that have traversed 10 or more ASNs must be denied.
* Routes accepted into ASN 65001 must be assigned a community value of 65001:200.
Which configuration must be engineer apply to the ASN 65001 border router?
- A.
- B.
- C.
- D.
Answer: C
Explanation:
Section: Networking
NEW QUESTION # 191
Refer to the exhibit:
It the NetFlow configuration is updated to version 9, which additional piece of information can be reported"?
- A. flow sequence numbers
- B. BGP AS information
- C. IPv6 flow information
- D. IPv4 flow information
Answer: C
NEW QUESTION # 192
Which CLI mode must be used to configure the BGP keychain in Cisco IOS XR software?
- A. mode BGP address-family configuration mode
- B. routing configuration mode
- C. BGP neighbor configuration
- D. global configuration mode
Answer: D
NEW QUESTION # 193
Drag and drop the OSPF area types from the left onto the correct statements on the right
Answer:
Explanation:
NEW QUESTION # 194
Refer to the exhibit.
An engineer is implementing BGP selective prefix suppression. The router must advertise only 10.16.4.0/24,10.16.5.0/24. and summarized route 10.16.0.0/21. and suppress 10.16.6.0/24. Which configuration must the engineer apply to the router?
A)
B)
C)
- A. Option C
- B. Option A
- C. Option D
- D. Option B
Answer: D
NEW QUESTION # 195
Refer to the exhibit. While troubleshooting the network, a network operator with an employee id:
3812:12:993 is trying to ping XR1.
Which result should the operator expect when trying to ping to an XR1 local address?
- A. All ICMP traffic is dropped.
- B. ICMP traffic works at a policed rate of 19 bytes per second every 100 ms
- C. ICMP traffic works at a policed rate of 19 packets every 100 ms.
- D. All ICMP traffic responds successfully.
Answer: D
NEW QUESTION # 196
When configuring traffic engineering tunnels in Cisco MPLS core network, a network engineer sees the traffic is not taking the expected path in the core. Which command must the engineer use to quickly check path of a TE tunnel?
- A. traceroute mpls ipv4 <tunnel destination>
- B. traceroute <tunnel destination IP>
- C. Ping <tunnel destination IP>
- D. show mpls traffic-engineering tunnels
Answer: D
NEW QUESTION # 197 
Refer to the exhibit. Which condition must be met by the OSPF peer of router R1 before the two devices can establish communication?
- A. The OSPF peer must use clear-text authentication.
- B. The interface on the OSPF peer may have a different key ID, but it must use the same key value as the configured interface.
- C. The interface on the OSPF peer must use the same key ID and key value as the configured interface.
- D. The OSPF peer must be configured as an OSPF stub router.
Answer: C
Explanation:
Section: Networking
Explanation/Reference: https://networklessons.com/ospf/how-to-configure-ospf-md5-authentication
NEW QUESTION # 198
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right
Answer:
Explanation:
Explanation:
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r5-3/mpls/configuration/guide/b-mpls-cg53x-crs/b-mpls-cg53x-crs_chapter_0110.html#con_1279822
NEW QUESTION # 199
A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred points for the customer AS?
- A. highest local preference outbound
- B. lowest multi-exit discriminator
- C. highest local preference inbound
- D. lowest local preference inbound
Answer: A
Explanation:
Section: Networking
NEW QUESTION # 200
Refer to the exhibit. On R1, which output does the show isis neighbors command generate?
- A.
- B.
- C.
- D.
Answer: C
NEW QUESTION # 201
How do intent APIs make it easier for network engineers to deploy and manage networks?
- A. They pull stored SNMP data from a single network location to multiple monitoring tools.
- B. They allow the engineer to use a single interface as the entry point for control access to the entire device.
- C. They extend the Layer 2 infrastructure and reduce the necessary number of virtual connections to Layer 3 devices.
- D. They streamline repetitive workflows and support more efficient implementation.
Answer: D
Explanation:
Intent APIs simplify the process of creating workflows that consolidate multiple network actions.
Thus, intent APIs create a shift from doing repetitive tasks to creating value-added solutions.
NEW QUESTION # 202
Refer the exhibit. Users on a network connected to router R3 report slow speeds when they connect to the server connected to R2. After analyzing traffic on the network, a network engineer identified congestion on the link between R2 and R3 as the cause. Which QoS service must the engineer implement to drop traffic on the link when it exceeds a configured threshold?
- A. class-based weighted fair queueing
- B. traffic shaping
- C. traffic policing
- D. first-in, first-out
Answer: C
Explanation:
https://www.cisco.com/c/en/us/support/docs/quality-of-service-qos/qos-policing/19645- policevsshape.html
NEW QUESTION # 203
......
Free 350-501 Dumps are Available for Instant Access: https://selftestengine.testkingit.com/Cisco/latest-350-501-exam-dumps.html